|
|
05-07-2011 08:45 PM | ||
oldtomcat |
Re: Most unusual or useful gadget/tool/jig I have a small lathe, that converts to many tools; overhead milling machine, small table saw,miter sander,drum sander,and router. I don't know if they are still made today; but they are available on ebay. Check them out. UNIMAT. OTC |
|
05-07-2011 02:26 PM | ||
hobbyjumper |
Re: Most unusual or useful gadget/tool/jig Not that unusual, but handy... |
|
05-07-2011 12:49 PM | ||
Beerwiser |
Re: Most unusual or useful gadget/tool/jig Fully stocked beer fridge and duct tape I can't think of anything else usefull that hasn't already been mentioned. |
|
05-06-2011 10:37 PM | ||
Xanadu |
Re: Most unusual or useful gadget/tool/jig So simple it's stupid that we never thought of it before. |
|
05-06-2011 10:32 PM | ||
Mooney_Driver |
Re: Most unusual or useful gadget/tool/jig Quote:
http://www.woodsmithtips.com/2011/05...sanding-block/ They had you draw the end outline of your piece (leading edge stock for example) on a piece of insulation foam. Then you shaped that foam and put the sanding paper over that. They were reproducing a cove cut but in our case we would cut out the foam so the piece that would become leading edge stock would have the right shape inside. This might not be the best way to make one but it is certainly cheaper than coming up with a router bit the right shape and routing one and would work well when only making a couple of leading edge pieces. There do not seem to be very many different sizes of leading edge stock available any more so this method would work for making your own. I have searched for info on how to make my own leading edge stock and after seeing the Woodsmith page I wondered why I had not thought of it since it is so simple but still fills the need. |
|
03-20-2011 02:03 PM | ||
Chrisfly |
Re: Most unusual or useful gadget/tool/jig A couple of things: I constantly use a good 'ol fashioned hand reamer to get the exact size hole I need quickly. It also is a great way to cut a taper in a prop to fit a tapered prop saver. I have a couple of different sizes and they will cut almost anything. Another favorite are magnetized parts dishes / trays. I got a bunch of sizes from Princess Auto for a few $'s a pop and they are worth their weight in gold. When working with tiny parts I work over one and so when (not if) I drop that tiny screw or c-clip it is captured for me and does not escape to the parallel universe! I also find it a great way to store the its and pieces as even if you knock it over nothing goes flying. |
|
03-20-2011 11:33 AM | ||
Guest |
Re: Most unusual or useful gadget/tool/jig ...and get your nickle back when your done! |
|
03-20-2011 10:29 AM | ||
marco2236 |
Re: Most unusual or useful gadget/tool/jig you can also turn over a beer/pop can . smooth dished surface |
|
03-20-2011 10:23 AM | ||
Xanadu |
Re: Most unusual or useful gadget/tool/jig I just use an old phone book. Squirt it on and mix, rip off the page when done, ready for the next time. Mixing cups way too expensive, when you can get these for free. |
|
03-20-2011 09:53 AM | ||
russ |
Re: Most unusual or useful gadget/tool/jig oh my, now I have to buy bottles instead of cans! |
|
This thread has more than 10 replies. Click here to review the whole thread. |