|
|
08-16-2014 10:39 AM | |
bhughes |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe Meh runs great |
08-16-2014 09:30 AM | |
Lorne @ Pro-RC.ca |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe I told you to retard the timing a bit brodie LOL. In most cases it is fine. If using a good fuel on the tune pipe you can sometimes here a little pinging if you don't retard it a couple of deg. Only takes a second either way |
08-16-2014 06:54 AM | |
bhughes |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe I am on mine and it seems to be running just fine for me |
08-16-2014 12:12 AM | |
Artp47 |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe Can you run the stock timing on the smoth pipe |
02-05-2014 11:32 PM | |
Lorne @ Pro-RC.ca |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe 26 deg todd |
02-05-2014 08:04 PM | |
Todd_Murray |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe Lorne. Did you use the default timing on the GP61 and Smoothpipe? If not, what did you use? Thanks Todd |
01-27-2014 07:27 AM | |
Lorne @ Pro-RC.ca |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe 24x9. Works great |
01-26-2014 10:55 PM | |
zdsh13 |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe Lorne, what prop are you using with your pipe setup? Was thinking of using a falcon 24x10 on my DA-60/ES Comp 55 setup. Looking forward to flying it, should be a powerhouse with a 60cc/pipe combo... |
01-13-2014 06:46 AM | |
Bdegan |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe I also like to use a 4/40 button head screw on the throttle instead of the usual socket cap. Head is a much lower profile and has better clearance Never pay again for live sex! | Hot girls doing naughty stuff for free! | Chat for free! |
01-12-2014 09:51 PM | |
bhughes |
Re: Light 3DHS 92" edge with GP61 & Smooth Pipe In florida what a holiday king lol. I had to file a little off my 4-40 head and a little on the motor to make it work. I would have used 2-56 but I didn't have any all thread in the tickle trunk. |
This thread has more than 10 replies. Click here to review the whole thread. |