|
|
|
| Beginners / Newbies Interested in getting in the hobby. Not sure where to start. Post your questions here and one of the RCCanada experts will be glad to help you out! |
Topic Review (Newest First)
|
| 10-29-2015 03:38 PM | ||
| u8mydog |
Re: Attaching FPV Camera I removed the plate and mounted the swivel to the frame using two bolts through the holes in the frame where the plate normally goes.. So it doesn't swivel but is sturdy enough and doesn't appear to amplify vibrations. |
|
| 10-26-2015 10:50 PM | ||
| Max |
Re: Attaching FPV Camera Quote:
Judging from the camera/case in the picture in post 1, I suspect it's very similar in size to the one I have. On mine I had a Sonny 700TVL camera and case. It would definitly not fit with my case. I had to take it out of the case, and even had to cut the PC board to the second level (the board is designed to do that) so that it would fit. Lots of hot glue is all it needed. Out of curiosity, can you post a couple of pictures of your camera setup? I'm away and cant take any pictures of mine at the moment, but can post a few next week when I get home. |
|
| 10-26-2015 09:57 PM | ||
| helinewguy |
Re: Attaching FPV Camera The pedestal off of course, but I've done it with Emax, zmr, qav, spacing was close but fits |
|
| 10-26-2015 09:47 PM | ||
| Max |
Re: Attaching FPV Camera Quote:
I think that case is way too big to fit in between the opening of that 250 frame. |
|
| 10-26-2015 01:36 AM | ||
| helinewguy |
Re: Attaching FPV Camera Put the camera behind the camera plate and use one zip tie above the lens and another below, it's what I've always done, as I prefer cameras in a case |
|
| 10-26-2015 12:40 AM | ||
| Max |
Re: Attaching FPV Camera Quote:
If you plan on using the existing case, you can mount the camera on top or in the front. HOT GLUE is your best friend as others have mentioned. Also, depending on where you got your camera and what else came with it, you should be able to remove the camera from the housing and it SHOULD fit inside the quad frame so that it looks through the opening in the front of the quad as you show in the picture. Then its HOT GLUE, HOT GLUE and HOT GLUE. |
|
| 10-25-2015 11:43 PM | ||
| TorontoR |
Re: Attaching FPV Camera at last resort, hot glue is your friend, followed closely by duct tape 
|
|
| 08-30-2015 12:31 PM | ||
| CHEVPRO |
Re: Attaching FPV Camera That plate is for a board camera. If you want to keep the swivel get rid of the plate. |
|
| 08-30-2015 12:29 PM | ||
| Wiliam |
Re: Attaching FPV Camera Zip ties ! |
|
| 06-07-2015 05:32 PM | ||
| obsoletepower |
Re: Attaching FPV Camera How attached are you to that swivel mount/camera case? |
|
| This thread has more than 10 replies. Click here to review the whole thread. | ||
Your Privacy Choices