|
|
|
| Construction Ideas, Hints and Tips For all the builders out there. Ask questions, make suggestions, trade tips. |
Topic Review (Newest First)
|
| 11-09-2011 06:11 PM | ||
| nahashmi |
Re: How to test fuel bottle for leaks Thanks Chuebner. Its a great tip. So far I've test two of my bottles successfully. Works easy and well. Cheers. |
|
| 11-09-2011 10:35 AM | ||
| grosbeak |
Re: How to test fuel bottle for leaks Quote:
|
|
| 10-29-2011 06:49 PM | ||
| Madman |
Re: How to test fuel bottle for leaks Well my 'method' was after installation. Use it to run a YS45. The engine pressurized the tank (the design of the engine puts about 8 psi into the fuel system) and a tank which worked fine on the bench spat its stopper and 10 oz of fuel into the plane. If in doubt Sulivan tanks work great. All others I have had have leaked at some time. Just my $0.02. Stephen |
|
| 10-29-2011 09:39 AM | ||
| JohnM |
Re: How to test fuel bottle for leaks Very wise decision to test before final placement. I have learned that lesson the hard way. I simply fill my tank with fuel (using a fuel pump) before putting it in the plane and observe what happens. Sure glad I did this a few weeks ago re. the plane I am putting together at the moment. The rubber stopper was defective and the tank was clearly leaking. Replaced the stopper and tested again - no problem. Cheers |
|
| 10-29-2011 06:25 AM | ||
| chuebner |
Re: How to test fuel bottle for leaks Put a fuel line(new) on the tank, hold under water and blow in the fuel lines or pressurize slightly with a pump. You will see any leaks. If in doubt, replace the stopper or tank assy. |
|
| 10-29-2011 02:10 AM | ||
| nahashmi |
How to test fuel bottle for leaks Can anyone suggest how to test the fuel bottle for leaks before placing it at hard-to-reach places in your RC plane ? |
|
Your Privacy Choices