|
|
|
| General RC Car & Truck discussion General Discussion about R/C topics |
Topic Review (Newest First)
|
| 10-05-2011 08:12 AM | ||
| imported_mavrick0 | You only need a 2 channel RX and a y-harness for the 2 ESC's. They will both plug into the y-harness and then into the throttle side of the ESC. Only thing you need to do is on one RX disconnect the red wire, either by cutting it off or pulling the pin out of the plug and shrink tubing it to avoid it shorting out. | |
| 10-04-2011 09:30 PM | ||
| imported_Leadfoot |
Quote:
|
|
| 10-04-2011 09:19 PM | ||
| Guest | you need a rx with 3 channels and mid 2 of the channels for throttle. | |
| 10-04-2011 09:15 PM | ||
| imported_Leadfoot | Would I just wire both reciever connectors into one plug to control them at the same time? | |
| 10-04-2011 09:11 PM | ||
| thrash metal |
re esc you would need 2 esc to run your 2 brushless motors anyways . you could use dual traxxas esc to power your motors |
|
| 10-04-2011 08:58 PM | ||
| imported_Leadfoot |
Quote:
What kind of esc would I be looking at then? |
|
| 10-04-2011 08:47 PM | ||
| thrash metal |
re 2 motors with 1 esc its unlikely a single esc will power 2 brushless motors especially the traxxas esc. i have seen rc boats with dual brushless motors but theres dual esc as well. |
|
| 10-04-2011 08:41 PM | ||
| imported_Leadfoot |
Two motors with one esc? I am considering running two traxxas Velineon 3500kv motors. My question is can one Velineon 3s esc handle both? Thanks. |
|
Your Privacy Choices