|
|
02-14-2013 06:01 AM | |
dee004 |
Re: MSR X Binding issue Think I will venture into the hobby shop tonight and see what they say. |
02-14-2013 06:00 AM | |
dee004 |
Re: MSR X Binding issue Have a timer now with the DX6i. When this happened I only had the E Flight transmitter. Maybe ten flights total. Main gear spins freely. |
02-14-2013 05:46 AM | |
hate repairing heli |
Re: MSR X Binding issue i found if you fly to cut-off it damages battery. try to use timer to land before that low. how many flights you have on msrx? can you spin main gear and motor by hand? i heard they have bad motors. |
02-13-2013 10:24 PM | |
dee004 |
Re: MSR X Binding issue No it didn't. I was practicing a steady hover when the low battery warning LED flashed in flight so I landed and changed the battery. When I reconnected the new battery this problem occurred. |
02-13-2013 06:20 PM | |
hate repairing heli |
Re: MSR X Binding issue well that is the way to bind. if you do that and the light wont go solid it might be antenna. you suffer a major crash? |
02-13-2013 07:07 AM | |
dee004 |
Re: MSR X Binding issue I also found and tried the following which also does not work, 1. Disconnect the flight battery from the helicopter. 2. Power off the transmitter and move all switches to the 0 position. 3. Connect the flight battery to the helicopter. The 3-in-1 Control unit LED flashes after 5 seconds. 4. Push in on the bind switch/button while powering on the transmitter. 5. After 2–3 seconds, release the bind switch/button. 6. Move the rudder control stick to full right. Continue to hold the rudder control stick to full right until the blue LED on the 3-in-1 control unit is solid. 7. Release the rudder control stick. 8. Disconnect the flight battery and power the transmitter off. |
02-13-2013 06:37 AM | |
dee004 |
Re: MSR X Binding issue Thanks. I've tried binding many many times to no avail. Please excuse my ignorance, but what is a full start up bind compared to the normal bind? |
02-13-2013 05:55 AM | |
hate repairing heli |
Re: MSR X Binding issue they sometimes lose bind. you have to do the full start up bind every once in a while. keep trying. |
02-12-2013 08:40 PM | |
dee004 |
MSR X Binding issue I was flying my MSR X and when I changed the battery it started acting like it went into bind mode. The problem is it will not re-bind to the E Flight transmitter and also my DX6i. I already have have an MCX and Ember 2 bound to the DX6i but the MSR X led just constantly flashes and will not bind. Has anyone else experienced this with any of the Blade products? I'm thinking I may have a defective 5 in 1 board. I sent a requisition to E Flight but haven't received a response from their technical department yet. Any ideas? |