|
|
|
| Multi Rotor Discussion Tri's, Quad's, Hex'as and more. Discuss anything multi-rotor, including multi-rotor stabilization and FPV setups. |
Topic Review (Newest First)
|
| 03-22-2015 05:40 PM | |
| jess232 |
Re: Need help with naze32 Hi thanks I moved to cleanflight and no problems whatsoever since. Jess |
| 02-20-2015 12:23 PM | |
| reelflyt |
Re: Need help with naze32 Hi . Go with Cleanflight firmware . They are constantly updating it and improving the performance . Gordon |
| 02-20-2015 07:21 AM | |
| uberjay |
Re: Need help with naze32 Hey Jess, Were you by chance flying in either Horizon or Angle mode? (Ie. auto level) If that's the case I wonder if it did the same thing in Acro mode. I've had accelerometer 'drift' before. Also, if it's the full naze board with Magnetometer, did you calibrate the magnetometer? Were you flying in heading hold mode? Lots of quesitons to your quesitons, I know.... Oh, the other thing you could try is jumping over to Cleanflight. Lastly.... did you update to the latest firmware? Thanks, J |
| 02-19-2015 07:46 PM | |
| jess232 |
Need help with naze32 Hey guys I have a 250 size quad with naze32 I flew it first flights with stock settings but I feel the yaw too slow so I decided to move up a little the rates in baseflight so I increased the yaw rate from 0.00 to 0.6 as well as pitch and roll from 0.00 to 0.45 and TPA from 0.00 to 0.4 then tried again. the yaw movement improved a lot however after flying around close to me some short circuits suddenly the yaw started to slow when rudder applied only LEFT when in the other hand while Turing RIGHT the rate felt good and responsive the issue didn't end up there because at some point there was no turning LEFT even with all rudder stick applied and even worse the quad started to spin right by itself!!!. Can anyone help?, will be appreciated, thanks. By the way when went back to base flight and tried to move he values of pitch and roll rate, yaw rate and TPA and tried to set them back to zero as stock, even after clicking SAVE the software shows as saved however I come back again to see the gains and no changes are made since the values are still 0.4, 0.6 and 0.4 respectively as after modified so it is not allowing me anymore to set them back to 0.00??????. Thanks |
Your Privacy Choices