|
|
10-24-2016 09:40 AM | ||
Mad Man Slice |
Re: KDS Chase 360 BTW, just posted all my spares in Classifieds "heli misc" |
|
10-24-2016 08:25 AM | ||
akabek |
Re: KDS Chase 360 Quote:
If you decide to keep your Chase 360 you mind as well hold on to those parts. If you sell them you will eventually need them. You know how it goes. |
|
10-24-2016 08:01 AM | ||
Mad Man Slice |
Re: KDS Chase 360 I wish I had a good recommendation of what to try but I dont. Mine is rock solid and completely stock. Running ar7200bx, MKS HV9780 tail servo and Halo CF tail blades. |
|
10-24-2016 07:53 AM | ||
akabek |
Re: KDS Chase 360 Hi Tim, do you have your tail locked in with your gain settings? If so are you using the stock tail section or did you upgrade to new tail assembly? Did you upgrade other parts? I am experiencing fast tail wag and even after dropping the gain down to 20 it is still their but much better. When spooling up there is no vibration and the wag only kicks in once it gets in the air. I rechecked the operating frequency for the KST DS215 tail servo and I increased it from 200 to 333Hz but I didn't get a chance to test it out yesterday due to the mishap. People are suggesting shims, thicker tail booms, aluminum tail booms, new tail servo etc to get the tail sorted. I find it hard to believe that we need to start messing with stock parts to get the heli dialed in. When I do the rebuild I will move the tail servo to the back and replace it with a MKS95i. |
|
10-23-2016 11:05 PM | ||
Mad Man Slice |
Re: KDS Chase 360 I agree, much better you were grounded when that occured. Good luck Rick! |
|
10-23-2016 10:42 PM | ||
akabek |
Re: KDS Chase 360 I am going to move my tail servo to the rear as well. I went to the field today to run up the Chase and check my tail wag situation. Unfortunately it tipped while taking off braking the tail boom, boom supports, vertical stabilizer and blades. After taking it apart I realized I installed the lower main shaft mount upside down so the bearing popped out. In hindsight it was probably better to happen while on the ground. Too bad I did not know about your parts earlier as I placed a couple of orders already. |
|
10-23-2016 10:12 PM | ||
Mad Man Slice |
Re: KDS Chase 360 Also, Rick or anyone else. I have about 45 spare parts (BNIB) for this heli that I think I'm going to sell off soon. Not sure if I will sell the heli yet..... But it does have a Xnova motor 2618-1860, & Hobbywing 50A up front. I will probably post in a day or two.... if interested. |
|
10-23-2016 09:57 PM | ||
Mad Man Slice |
Re: KDS Chase 360 Here it is Rick! |
|
10-23-2016 09:46 PM | ||
Mad Man Slice |
Re: KDS Chase 360 It's @ the rear position |
|
10-23-2016 09:30 PM | ||
akabek |
Re: KDS Chase 360 Tim, is your tail servo at the front or rear position? |
|
This thread has more than 10 replies. Click here to review the whole thread. |