|
|
|
| Electric RC Helis Discuss helicopters, setups and power systems for electric helicopters. |
Topic Review (Newest First)
|
| 04-05-2013 03:54 PM | ||
| sliderx |
Re: mcpx question I brought the Heli used here On RCCanada so taking it back to the lhs is not possible. It came with this swash plate. Right now for me the rubber band around the outside of the 2 links is working good and it hovers really well. I have another swash but it fits the same way. Until I need a new one I'll keep using it this way. With this setup it can't pop off. Art |
|
| 04-05-2013 03:38 PM | ||
| Colin Broughton |
Re: mcpx question Microheli swash plates have been known to have undersized balls, I had to send one back due to this and when I did they told me there was alot that went out this way. Your not the only one, take it back to your lhs. |
|
| 03-24-2013 02:27 AM | ||
| VooDooMafia |
Re: mcpx question Most people add o rings to reduce the slop. It's all personal preference but I think it helps |
|
| 03-20-2013 07:12 PM | ||
| sliderx |
Re: mcpx question My problem is the link is to big for the ball. I through of using a "O" ring behind the link but was afraid it would push it to far out on the ball so I went the other way with a rubber band to pulling it onto the ball. The top of the link at the blade holders is OK. Art |
|
| 03-20-2013 06:06 PM | ||
| moo |
Re: mcpx question I totally agree the slop has to be removed but... are the both of you saying your links are too big or your balls are too small? |
|
| 03-20-2013 06:02 PM | ||
| Vadimus |
Re: mcpx question Quote:
|
|
| 03-20-2013 05:30 PM | ||
| sliderx |
mcpx question I have an Mcpx that I have a question about. On the link from the swash plate to the rotor head the end that goes to the swash plate is a little loose on the ball of the swash plate. This is a Microheli alum. swash plate. I have other new links and they all fit the same way. I have remedied this a bit by putting a small rubber band that goes around the out side of the two links kind of pulling them in on the ball. I have flown it this way and it seem to work well and the Heli fly's smooth. I was wondering if anyone else had this problem. Is there a better brand of swash plate that I could use? Art |
|
Your Privacy Choices