Futaba CGY 750 Gov with CC160 aux wire
 

I'm wanting to set up the governor in the CGY750 using the aux line from the CC160 into the R.Sen port on the CGY for rpm read. My Tx is a Futaba 18SZ, CGY is updated to v2.0

I've read the manuals, searched the forums, but I'm still unsure if I'm setting this up correctly. Other than Dereks vids on utube (which shows cgy gov set-up in v1.4) Are there any other gov set-up tutorials available for v2.0 along with the 18SZ??

I know I maybe asking a lot, but dumbarses like me need step by step instructions sometimes.

Thanks