training gear setup
 

I have a blade cp and am trying to figure out how the training set conects to it. The tarining set has the four arms with the ping pong balls on the end with a center piece that they connect to. What I can't figure out is where to connect them to the heli.

:(

training gear
 

garbage bag twist ties, right to the skids. Make sure you center the gear in relation to the mainshaft so it's balanced.

Todd

mine has little snap on pieces on the skids with holes in them so you just thread the arms through the holes and connect them to the center piece and then you dont have to worry about balancing

I couldn't figure mine out either. So I used ty wraps. I had a bag of 1000 kicking around, otherwise, garbage ties would work fine too. Don't glue it though (I tried it first). The hammering on the ends of the gear makes the landing gear break.