AR 7200BX problem
 

Hi Guys.I just bought AR7200 BX for my Trex250.On the step 5 when I tried to setup cycles servos( I had 3 servos HS65MG) they smoked and burn out.I changed for 3 HS5065MG(digital).They are gone too.I didnt overload servos.May be somebody give me some idea regarding this thinks?
I have Kontronik Jass 20.
Thanks.

Re: AR 7200BX problem
 

What is your reciever voltage and did you check operation before hooking up servo linkage?

Re: AR 7200BX problem
 

Receiver(BesatX system) required 3,5-8.5V.My output voltage from Kontronik Jass 20 6V.Servos gone not right away but after 1 hour installment.

Re: AR 7200BX problem
 

They are working half an hour.

Re: AR 7200BX problem
 

Did you set the proper frequency in BeastX for those servos?
http://www.beastx.com/service_servoliste.html

Re: AR 7200BX problem
 

I setup for Hitec 50 HZ

Re: AR 7200BX problem
 

It is a mystery.It is a new model Spectrum with BeastX in one case.

Re: AR 7200BX problem
 

Has one one used AR7200BX?

Re: AR 7200BX problem
 

Maybe its faulty..Have you tried contacting them?.Sorry about your bad luck

Re: AR 7200BX problem
 

Thanks.