RCCanada - Canada Radio Controlled Hobby Forum - View Single Post

Dave Holmes · 05-11-2004, 08:50 AM

Gary

If it is a problem where the receiver is prone to vibration problems, you can test it on the bench with one or two servos plugged in. Just hold it against your dremel tool as you vary the speed of the tool. that will vibrate it and if the servos act squirrely, you just elimanated all the rest of the rig as the source.

Dave

05-11-2004, 08:50 AM	#13
Dave Holmes RCC Supreme Contributor I am: Dave Holmes Join Date: Mar 2004 Location: Prince Edward County, Ontario (no longer Brampton!) Radio of choice: Futaba 72 Mhz # of RCs: 30+ Feedback: 4 / 100% Posts: 4,393 Total Props: 16	Gary If it is a problem where the receiver is prone to vibration problems, you can test it on the bench with one or two servos plugged in. Just hold it against your dremel tool as you vary the speed of the tool. that will vibrate it and if the servos act squirrely, you just elimanated all the rest of the rig as the source. Dave __________________ Dave Holmes The older I get, the better I used to be!