RCCanada - Canada Radio Controlled Hobby Forum - View Single Post

JBoyd · 03-01-2011, 06:43 PM

What I did is this: instead of cutting the covering out around the hole, I just cut and X from corner to corner. This allows me to slip the servo in and not have any loose covering that can get caught by the wind. As long as the servo isn't smaller than the mounting hole in the balsa then it should fit snuggly up against the cut covering.

03-01-2011, 06:43 PM	#6
JBoyd RCC Junior Contributor I am: Jason B. Join Date: Jan 2011 Location: Kelowna, B.C. Radio of choice: DX6i # of RCs: 1 Feedback: 0 / 0% Posts: 139 Total Props: 0	Re: Cutting servo hole in ultracote What I did is this: instead of cutting the covering out around the hole, I just cut and X from corner to corner. This allows me to slip the servo in and not have any loose covering that can get caught by the wind. As long as the servo isn't smaller than the mounting hole in the balsa then it should fit snuggly up against the cut covering.