RCCanada - Canada Radio Controlled Hobby Forum - View Single Post

Flypaper · 06-20-2012, 07:45 AM

Here's one used on a pushrod end. With this setup, no need for a Z bend. Heatshrink a .010 wire with it. I put a small bend in the end of the wire in the heatshrink to help keep it from pulling out. I also use the heatshrink on the Orange HK rcvrs when I take the plastic case off. The plastic case weighs the same as the rcvr itself.

06-20-2012, 07:45 AM	#9
Flypaper RCC Pro Contributor I am: Gord C Join Date: Sep 2002 Location: kingston Ont. Feedback: 1 / 100% Posts: 1,863 Total Props: 8	Re: What's the point of heat shrink tubing? Here's one used on a pushrod end. With this setup, no need for a Z bend. Heatshrink a .010 wire with it. I put a small bend in the end of the wire in the heatshrink to help keep it from pulling out. I also use the heatshrink on the Orange HK rcvrs when I take the plastic case off. The plastic case weighs the same as the rcvr itself. Attached Thumbnails __________________ Tried for my kamikazi pilots licence. Flunked the test. Gord. MAAC 5276