RCCanada - Canada Radio Controlled Hobby Forum - View Single Post

Guest · 05-23-2010, 10:25 AM

Make a simple tool which is a pin that goes through the one lifter liner and locks the cam in place. There is a hole on the camshaft for this. Make sure the engine is top dead center and drop the camshaft housing in place. You can always make one.

http://www.lismoremodelflyingclub.or...tes/saito.html

Step by step rebuild including use of timing tool
http://www.authorstream.com/Presenta...pt-powerpoint/

Article (Fly RC) by our own Andrew C

http://www.flyrc.com/articles/4stroke_howto.html

Dennis

05-23-2010, 10:25 AM	#14
Guest Guest Join Date: Sep 2002 Feedback: 0 / 0% Posts: 0 Total Props: 57	Re: Saito .91 would'nt run but is ok now Make a simple tool which is a pin that goes through the one lifter liner and locks the cam in place. There is a hole on the camshaft for this. Make sure the engine is top dead center and drop the camshaft housing in place. You can always make one. http://www.lismoremodelflyingclub.or...tes/saito.html Step by step rebuild including use of timing tool http://www.authorstream.com/Presenta...pt-powerpoint/ Article (Fly RC) by our own Andrew C http://www.flyrc.com/articles/4stroke_howto.html Dennis