[mjohnson]

Thanks flitelab

I installed all the electronics today and fired 'er up!! I had a little wobble but after turning the roll pot on the HK KK board down a little is settled right down. I did this by holding it over my head and hanging on to it to check all control functions. I had it just hovering with barely any touching from my hand and after a couple of trim adjustments it will hover in a very stable manner. It is raining cats and dogs here now so I can't get out side for a full hover check. Can't wait for a bit of dry weather but according to the weather guesser it will be a while.

Cheers

MJ