[Struts1]

Originally Posted by LPII

Hi, there. If you happened to bind the receiver with the throttle in the high position (ie, to enter programming mode), this could be the source of your problem, because the receiver will remember this as the low throttle position, and not arm the ESC in any other throttle position. Have you tried re-binding the receiver with the throttle in the low position? Since you programmed the ESC with the card, you shouldn't have to enter programming mode with the throttle stick.

Hey,

RX was binded properly and have been working perfectly. I have since reprogrammed the ESC on the card and tried to use it with stick in fully down position, yet it's beeping with 2 sec intervals in between each beep. Beeps are not beeping as it was before, so the pattern of beeps have changed yet ESC is not arming nor going into programming with throttle stick in top position. What to do next?