RCCanada - Canada Radio Controlled Hobby Forum - View Single Post

**williame3590** · 02-10-2012, 09:19 PM

Here is the balsa cowl and fibreglass wheel pant Struts. The pants actually require a fair amount of bondo and putty because of the raised seem that runs down the middle.
This is all painted with ICI (Glidden) good old fashioned rattle cans. Lots of wet sanding between coats.
I can get large areas like wings to come out the same, just a little tougher.
ICI also has a high build primer in a rattle can which I used on these. It will fill a weave in about three coats. These are all oil based products.

Bill

02-10-2012, 09:19 PM	#14
williame3590 Administrator ★ Site Supporter ★ ★ Site Supporter ★★ Administrator ★ I am: William A Join Date: Mar 2006 Location: York, on Radio of choice: Futaba Feedback: 129 / 100% Posts: 10,204 Total Props: 116	Re: High fill primer... Here is the balsa cowl and fibreglass wheel pant Struts. The pants actually require a fair amount of bondo and putty because of the raised seem that runs down the middle. This is all painted with ICI (Glidden) good old fashioned rattle cans. Lots of wet sanding between coats. I can get large areas like wings to come out the same, just a little tougher. ICI also has a high build primer in a rattle can which I used on these. It will fill a weave in about three coats. These are all oil based products. Bill Attached Thumbnails __________________ ''engine hoarder''