RCCanada - Canada Radio Controlled Hobby Forum - View Single Post

mwavesdave · 11-10-2014, 05:54 PM

So, as I'm going with two elevator servos, and pull pull rudder setup, I needed to run the cables for the rudder, check for interference, and then add some balsa to allow for the covering. All went fast, so that's done. Then it was on to covering the vertical stab, elevators, and rudder. Horizontal stab will be next.

11-10-2014, 05:54 PM	#21
mwavesdave Guest I am: Dave R. Join Date: Aug 2010 Location: Halifax Radio of choice: Futaba 7C 2.4 # of RCs: 12+ Feedback: 46 / 100% Posts: 4,981 Total Props: 24	Re: PICA 1/5th WACO So, as I'm going with two elevator servos, and pull pull rudder setup, I needed to run the cables for the rudder, check for interference, and then add some balsa to allow for the covering. All went fast, so that's done. Then it was on to covering the vertical stab, elevators, and rudder. Horizontal stab will be next. Attached Thumbnails