[bugsmasher]

I recently bought a Eachine 180 Assassin ARF with a Naze32 board but haven't been able to get it going. It included no wiring sequence but I found one online. I'm still not sure it's wired right but it powered it up and I was able to bind it. Arming it has been impossible though. I hooked it up to cleanflight and had no problem flashing the latest firmware and making online recommended settings but it just won't arm. The other problem is that it won't connect when the battery is connected. I should be able to connect with the battery connected and see live stick positions etc? If it's connected and I install the battery is disconnects and if I try to connect with it powered up I get the message "No configuration received within 10 seconds, communication failed". I'm thinking something is fried but it's odd that I can change settings and flash new firmware. I built a quad from scratch with a different board and had no problems setting it up but with this one I'm stumped. I'm almost at the point I'm going to pull the motors and camera and toss the rest in the garbage. Any ideas? Thanks.

[geotric]

Originally Posted by bugsmasher

I recently bought a Eachine 180 Assassin ARF with a Naze32 board but haven't been able to get it going. It included no wiring sequence but I found one online. I'm still not sure it's wired right but it powered it up and I was able to bind it. Arming it has been impossible though. I hooked it up to cleanflight and had no problem flashing the latest firmware and making online recommended settings but it just won't arm. The other problem is that it won't connect when the battery is connected. I should be able to connect with the battery connected and see live stick positions etc? If it's connected and I install the battery is disconnects and if I try to connect with it powered up I get the message "No configuration received within 10 seconds, communication failed". I'm thinking something is fried but it's odd that I can change settings and flash new firmware. I built a quad from scratch with a different board and had no problems setting it up but with this one I'm stumped. I'm almost at the point I'm going to pull the motors and camera and toss the rest in the garbage. Any ideas? Thanks.

Well my only advice is go on rcgroups.com and look for the Eachine 180 assassin . There is a guy Soloprofan from Holland . He will help you.
Good luck.