Best 3d Deperon Profile Plane Set Up
I have been experimenting with the best set up possible for my 3d deperon foam plane. Here is the best set up i have come up with.
370 brushless motor 1200-1500k,18amp ESC, 3 cell 730ma lipo and 9x3.8 spinner with no prop saver cause it deflects it to much, I also used a servo for each aerlerone. I find with this set up i got good speed and awsome torque with 15+ minutes of flight time. I also find that the GWS spinners deflect to much also so I am using a more ridged spinner that cost me $3.50, less than $1 more than the gws one.
If any of you guys out there are leary about spending the money on a brushless system than go with the TTR christian eagle or the TTR expo 3d. I found that both of these planes are good with the stock power systems they come with as long as your flying outside only. For indoors a lighter brushless system allows the plane to be flown at a slower speed which is a must for indoor flying. I hope this information is useful to some of you guys who may be interested in getting into electric 3d flight.
Nino
|