|
|
Crawling Discussion A place to exchange ideas and post information on crawling |
|
Thread Tools | Display Modes |
01-31-2008, 06:25 PM | #1 |
RCC Senior Contributor
I am: Edgar T.
Join Date: Jul 2007
Location: Brampton On.
Radio of choice:
Spectrum Dx3 pro # of RCs: 8
Feedback: 12 / 100%
Posts: 519
Total Props: 0
|
AX10 scorpion
hi guys , just finished building my 1st crawler , pretty much stock still with a Hitech ultra torque HS-645MG servo and a trinity 27t tweaked motor ! let me know what u think and what u wud change on it, thanks !
|
. |
Sponsored Links - Subscribe to remove this ad. |
|
|
|
01-31-2008, 07:40 PM | #7 | |
RCC Senior Contributor
I am: Edgar T.
Join Date: Jul 2007
Location: Brampton On.
Radio of choice:
Spectrum Dx3 pro # of RCs: 8
Feedback: 12 / 100%
Posts: 519
Total Props: 0
|
Quote:
thanks !!!!!! |
|
. |
01-31-2008, 08:04 PM | #8 |
RCC Expert Contributor
I am: Bill
Join Date: Mar 2007
Location: Queensville , ontario
Feedback: 0 / 0%
Posts: 832
Total Props: 0
|
sit the truck in front of you with the hood away from you. then look down at the back of the truck, and the one on your left is the one to stiffen up.
as well, that shell may not meet the requirements for the amount you cut off of it, but your off to a good start so far. you will want to do weights in the wheels. i run 6 ounces in each front wheel and 4 in each rear wheel. the battery location, you gotta get that battery down low on the front axle. also try some micro packs if you can get your hands on them. most use 2/3 A cell packs for there crawlers now.... |
. |
01-31-2008, 09:36 PM | #10 | |
RCC Senior Contributor
I am: Edgar T.
Join Date: Jul 2007
Location: Brampton On.
Radio of choice:
Spectrum Dx3 pro # of RCs: 8
Feedback: 12 / 100%
Posts: 519
Total Props: 0
|
Quote:
|
|
. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|