|
|
Construction Ideas, Hints and Tips For all the builders out there. Ask questions, make suggestions, trade tips. |
|
Thread Tools | Display Modes |
02-15-2005, 06:44 AM | #1 |
RCC Contributor
I am: Steven Dew
Join Date: Jun 2004
Location: Sault Ste Marie, Ont
Radio of choice:
Futaba # of RCs: 50
Feedback: 0 / 0%
Posts: 337
Total Props: 0
|
Pull-Pull Setup on 28%
Installing a pull pull set up on a 28%
aerobatic plane. The hardware included is a Dubro pull pull kit 4-40 with some steel couplers and wire. Question Do you guys that fly IMAC use this setup? I propose to use the steel cable and couplers, but will put some heat shrink over the couplers just to keep it from vibrating. I'm hoping this will not cause radio interference. What do you do?????
__________________
SAD MAAC #23584L IMAC #4335 Past President Soo Modellers |
. |
Sponsored Links - Subscribe to remove this ad. |
|
02-15-2005, 08:00 AM | #2 |
RCC Supreme Contributor
I am: Ronm
Join Date: Dec 2002
Location: Mission, B.C.
Radio of choice:
Futaba # of RCs: 10
Feedback: 0 / 0%
Posts: 5,625
Total Props: 0
|
I use these, should be fine.
I try not to run the antenna too close to the metal wires.
__________________
Ron Mattiuz Flying Tigers RC Club "Flying an airplane is just like riding a bike...except it's harder to put cards in the spokes" |
. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|