Register Now

Flyin High · 04-14-2007, 03:20 PM

I am just wondering how you sync dual aileron servos? is there any tricks or is it straight forward? I'd appreciate any help.

SJrcflyer · 04-14-2007, 04:23 PM

Do you mean trying to match up just straight anolog servos?? Or do you mean digital servos?

For anolog easiest way is to make the servo arm as close to 90* to the servo case as possible. Next change you pushrod length to match the servo travel appropriately. Try to avoid subtrims as you are changing the center of the servo as well as it will effect the speed of the servo. If you have to do fine adjustments use endpoints to tweak it.

For digital, if hitec; go buy a programmer, if JR; go buy a matchbox.

Thats the way I would do it, i'm sure others will have different opinions.

For a ton more information check this out:

http://www.downonthedeckdiscussion.c...r=asc&start=15

FaceDeAce · 05-14-2007, 12:13 AM

Another way is with this:

https://www.rccanada.ca/bb/viewtopic....hlight=harn%2A

04-14-2007, 03:20 PM	#1
Flyin High RCC Senior Contributor I am: Bob S Join Date: May 2004 Location: Beeton, Ontario Feedback: 4 / 100% Posts: 592 Total Props: 0	Syncing servos? Remove this ad - become a site supporter! I am just wondering how you sync dual aileron servos? is there any tricks or is it straight forward? I'd appreciate any help. __________________ -Bob
	.

05-14-2007, 12:13 AM	#3
FaceDeAce RCC Supreme Contributor I am: Claude P. Join Date: Sep 2002 Location: Great Western Radio of choice: Futaba 7C and 9C, Prism 7x # of RCs: 20+ Feedback: 8 / 100% Posts: 2,092 Total Props: 1	Another way is with this: https://www.rccanada.ca/bb/viewtopic....hlight=harn%2A __________________ Work Hard, Play Harder
	.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-14-2007, 04:23 PM	#2
SJrcflyer RCC Senior Contributor I am: ChisR Join Date: Aug 2005 Location: Saint John, NB Feedback: 0 / 0% Posts: 607 Total Props: -4	Do you mean trying to match up just straight anolog servos?? Or do you mean digital servos? For anolog easiest way is to make the servo arm as close to 90* to the servo case as possible. Next change you pushrod length to match the servo travel appropriately. Try to avoid subtrims as you are changing the center of the servo as well as it will effect the speed of the servo. If you have to do fine adjustments use endpoints to tweak it. For digital, if hitec; go buy a programmer, if JR; go buy a matchbox. Thats the way I would do it, i'm sure others will have different opinions. For a ton more information check this out: http://www.downonthedeckdiscussion.c...r=asc&start=15
	.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

vBulletin Message

Cancel Changes

Register Now

Log-in