[Trumpetman]

Dale, could you do me a favor? I need to know where the balance point is located on your big Ultimate. If you could give the wing span, chord measurement and the factory CG point I can scale it up or down for my slightly modified Ultimate LOL. Thanks!

[Bdegan]

Gordon,

My 50% modelbau ultimate was at the rear of the center cabane .

My 50 cc aeroworks ultimate and smaller Dave Patrick were all the same location.



Never pay again for live sex! | Hot girls doing naughty stuff for free! | Chat for free!

[cravenjw]

Originally Posted by TBrum

LOL!! Well, I'll try my hardest, but may add in my specialty move that will make Lorne happy... THE SPINNER DIP.

Don't forgot the patented TBrum "flat spin" landing! I always enjoy watching you execute that move! Lol

[TBrum]

Yep!! I've practiced that one quite a bit!! I just have to stop acting surprised when it happens in the future

[cravenjw]

Actually you just have to work on the "I meant to do it poker face" !

[Trumpetman]

Originally Posted by Bdegan

Gordon,

My 50% modelbau ultimate was at the rear of the center cabane .

My 50 cc aeroworks ultimate and smaller Dave Patrick were all the same location.

Hi Brad, I'm not sure the rear of my centre cabane is in the same location as yours LOL Any chance you have the measurements from your big bird??

[Bdegan]

Originally Posted by Trumpetman

Hi Brad, I'm not sure the rear of my centre cabane is in the same location as yours LOL Any chance you have the measurements from your big bird??

No, no measurements.

But your wings and base set up are an Ultimate. It should give you a good starting point to work from. Most Ultimates are very similar in wing placement and wing stagger.



Never pay again for live sex! | Hot girls doing naughty stuff for free! | Chat for free!

[Dale Hunter]

Originally Posted by Trumpetman

Dale, could you do me a favor? I need to know where the balance point is located on your big Ultimate. If you could give the wing span, chord measurement and the factory CG point I can scale it up or down for my slightly modified Ultimate LOL. Thanks!

http://www.hangar-9.com/Products/Sup...ProdID=HAN1100
The bottom manual has the balance point, etc.
Hope this might help.
As for the airframe. All in the little cargo trailer at the flying field, ready for spring.
-Dale-









.



100% free webcam site! | Awesome chicks and it is absolutely free! | Watch free live sex cam - easy as 1-2-3

[Dale Hunter]

Originally Posted by TBrum

Hey Dale.. would the Show and Shine allow members of the E.M. to attend???

It just so happens I have a very important meeting in Edmonton on the Friday

I tell ya Jack.
I announce daily flight demonstrations from WingBurner. They start coming from hell knows where.
-Dale-








.



100% free webcam site! | Awesome chicks and it is absolutely free! | Watch free live sex cam - easy as 1-2-3

[NDW]

Fooling around in the shop tonight.... not sure how to describe this but could have a nice bling effect. Took me about 1/2hr to make it and it cost under $10' including the cost of the can. I preasureind it and put in the laundry tub submerged for a couple hours with no air escaping. Went to home depot and found an "O" ring that fits perfectly under the cap to aid in sealing. Just need to pick up some Viton tubing at thunderbolt next weekend if they are at the Kitchener swap meet. Anyways who new another source of hobby stuff is located at the "Beer Store".