Register Now

phattires · 04-26-2007, 08:42 AM

Hi everyone

The build on my Raptor 50SE is nearing completion. I am powering it with the OS 50 Hyper motor. At some point ( hopefully soon ) I will have to crank this puppy over. What should i be looking at in regards to a starter extension.
I will be using the Sullivan Dynatron Super Hi-Tork Starter. I have not used a starter extension in the past so unsure as what to look for. Maybe something that bolts up to this starter to eliminate slippage from the rubber starter insert.
The last heli I was starting was a little shuttle, and using the starter belt.
Your input / recommendations would be appreciated.
Thanks to all
Mike

aarinsingh · 04-26-2007, 04:32 PM

I started all my rappies with the the cheapest, non bearing'd shaft I could find. I still uses the kind the plug into the rubber cups on the starter to start my .90 so I don't see any real value in the bolt-ons.

Guest · 04-26-2007, 06:49 PM

Mike, I see you are in Brampton, close to Hobby Hobby.
You should go in there and talk to Kevin or Tom. I'm sure they will be able to fix you up.
Joe

04-26-2007, 08:42 AM	#1
phattires RCC Junior Contributor I am: Mike B Join Date: Dec 2003 Location: Brampton, Ontario Radio of choice: JR 9503 Feedback: 5 / 100% Posts: 214 Total Props: 0	Starter Extensions Remove this ad - become a site supporter! Hi everyone The build on my Raptor 50SE is nearing completion. I am powering it with the OS 50 Hyper motor. At some point ( hopefully soon ) I will have to crank this puppy over. What should i be looking at in regards to a starter extension. I will be using the Sullivan Dynatron Super Hi-Tork Starter. I have not used a starter extension in the past so unsure as what to look for. Maybe something that bolts up to this starter to eliminate slippage from the rubber starter insert. The last heli I was starting was a little shuttle, and using the starter belt. Your input / recommendations would be appreciated. Thanks to all Mike
	.

04-26-2007, 04:32 PM	#2
aarinsingh RCC Junior Contributor I am: Aarin S Join Date: Oct 2003 Location: Thompson Feedback: 0 / 0% Posts: 140 Total Props: 0	I started all my rappies with the the cheapest, non bearing'd shaft I could find. I still uses the kind the plug into the rubber cups on the starter to start my .90 so I don't see any real value in the bolt-ons. __________________ SHAG 2009 http://shag.hobby-site.com
	.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

04-26-2007, 06:49 PM	#3
Guest Guest Join Date: Sep 2002 Feedback: 0 / 0% Posts: 0 Total Props: 57	Mike, I see you are in Brampton, close to Hobby Hobby. You should go in there and talk to Kevin or Tom. I'm sure they will be able to fix you up. Joe
	.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

vBulletin Message

Cancel Changes

Register Now

Log-in