[TBrum]

A few shots of the turtledeck covered also!!

Boy that's a lot of yellow, LOL!! And ultra-chunky

This afternoon I'll cover the rudder in yellow and tonight I'll start applying all the crazy swoops and the lower black fuse trim

[FLYINCHASE]

Man your a machine!!!!! That looks great..........

Thanks
Mike

[TBrum]

Nothing special Mike!!... just lots of hours in the w-shop, LOL!!!

Thanks!

[TBrum]

Here's a shot of the bottom left side of the fuse finished with the black mulit-swoop

[TBrum]

I decided, before doing the multi-swoop on the right side, that I'd install the (3) BLS172HV servos in the tail for rudder and elevators.

Also had to cover the rear-hatch door.

All these arms are Secraft 2" V2, but I'm gonna need to go to 1.5" on the elevator servos to clear the rudder servo arm.

[TBrum]

Rudder covered, horn installed, hinge pin permanently installed and hinge gap sealed

With that 2" servo arm, I'll be able to have some "Do'in the Andy" throw, LOL

[TBrum]

Base fuse covering completed

Tonight I can start on all those painful swoops
.
.
.
Like decorating a Christmas tree, LOL

[TBrum]

I had a swoop'n good time tonight in the shop, LOL!
.
.
Just kidding - nothing fun about it Definitely the most challenging covering scheme to date

Swoop #1, #2 and #3 done

[TBrum]

In order to do Swoop #4, I had to do a rough mask of the paint lines on the cowl and then continue it on the fuse.

I did both sides while I was at it, LOL!!

[TBrum]

There... Swoop 1-4 done on the front of the left side
.
.
Tomorrow I'll go hard at the right side