[AJCoholic]

OK, thought I'd start a new thread to keep this organised.

Unfortunately, I am 150km away from my desktop and I can't open up my "aresti made easy" CD on my laptop since I dont have power point on it. So, I am going to try this from memory.

PLEASE correct my mistakes, and I will try and learn as I go Sorry for being wordy or a bit confusing - I tried my best!

(using the B sequence, wind from the right)

#1 - figure N

pull to vertical upline, one complete roll (either way, pilots choice)
pull to inverted 45 degree downline with one negative snap in the centre
push to vertical upline
push to upright horizontal exit

#2 - teardrop

1 1/2 upright spin (pilot chooses direction)
1/2 roll on the downline (pilot chooses direction - however must be opposite of spin)
5/8 inside loop
2 points of a 4 point roll on 45 degree upline
push to horizontal upright exit

#3 - loop with 1/2 roll

enter level upright, push to outside 1/2 loop
1/2 roll at the bottom (pilot's choice for direction)
complete maneuver with 1/2 inside loop
exit horizontal inverted

#4 - vertical downline

from inverted entry, pull to vertical downline
3 points of a 4 point roll to the left (choice of pilot, but in order to get you going out)
push to inverted level flight outwards

#5 - cross box humpty

inverted entry flying out
push to vertical climb, with 4 points of an 8 point roll (pilots choice of direction)
pull over the top
2 points of 8 point roll to the right (or opposite of the roll direction chosen in #4)
pull to upright horizontal exit to the right

#6 - sharks tooth

horizontal upright entry
pull to inverted 45 degree upline with two 1/2 rolls (pilots choice direction)
pull to vertical downline with one positive snap in the middle
pull to upright horizontal exit

#7 - hammerhead

upright horizontal entry, pull to 45 degree upline
pull to vertical upline with 1/2 roll (pilots choice direction)
hammerhead
vertical downline with 1 full roll on the downline
push to inverted horizontal exit to the left

#8 - 45 upline

from inverted, push to 45 degree inverted upline
4 point roll
pull to horizontal inverted exit

#9 - 1/2 loop

from inverted horizontal flight, one negative snap
1/2 inside loop
1 positive snap
exit upright horizontal to the right

#10 - one 90 degree rolling turn, one complete roll to the inside while doing a 90 degree turn to the left
exit upright horizontal flight going out