[BigJohn]

http://www.hobbyking.com/hobbyking/s...ESC_w_UBEC.htm
Here is the link to the controller I have. Works great but for the life of me I am trying to change the program to use in a airplane. The problem is when I start it goes into a hold with low thottle setting then after a few seconds lets me go to full throttle. I downloaded the manual but just can't seem to get past the hold on startup. Any advice besides just buy a airplane controller, LOL. John

[cassat]

John,

Its called "softstart" in the program menu.
Best bet is to buy a programming card, probably a Turnigy would work
for $9.00

[BigJohn]

Originally Posted by cassat

John,

Its called "softstart" in the program menu.
Best bet is to buy a programming card, probably a Turnigy would work
for $9.00

I know the setting you are talking about but in the program guide under throttle settings it shows Soft Ace so I have just tried that. Didn't work as its still will start with a low trottle setting and hold at that than within about 5 sec's it will allow the motor to spool up. It could work like that but I wouldn't feel very safe just in case I went to low on the throttle setting and it didn't come up for 5 sec's. I'm going to post the manual in hopes someone might be able to dirrect me in the right path. I will talk to a friend that has a HK program card and try that as well. Thanks, John

[Flavors]

if i remember right the softstart cant be remove on those... the only thing you can program is the type of battery , cutoff , brake . Well that was on the 20 amp version im not sure about this one . And the SS esc serie cant be programed via a card only with the TX sorry .