[scaleguy]

Originally Posted by Second time around

by the stores.
Will I still shop Hitec certainly .
Why - Also they have a forum that is covered 5 days a week by technitions there service is great.

So have you asked them about the reported problems with Karbonite Gears>

I had 4 of these servos in a H9 CAP that did a swan dive into the ground, (Not because of the servos ). When I checked them out after the INCIDENT, they were fine. Don't know much more of a test then that.

Remember if flutter occurs even metal gear servos will fail, given enough time.

Hey if the ARGOS aren't playing.....who cares!

[Second time around]

Here is there reply


Author Topic: 635 karbonites
Red Neck
Rate Member posted November 26, 2005 07:10 AM
--------------------------------------------------------------------------------
I am just finishing up a sig rascal 110 inch wing span. I have installed a evolution g26 (Gas)motor in it . I have some hi tec 635 hb servos with karbonite gears that tourqe out at 69 oz. at 4.8 volts.
Do you think these will be sufficant for a sport flyer of this size.
If not what would your suggestion be .
Red neck
--------------------------------------------------------------------------------
Posts: 4 | IP: Logged

Stevo
Administrator
Member # 2506

Member Rated:
posted November 28, 2005 12:05 PM
--------------------------------------------------------------------------------
That will be fine for that.

--------------------
Steve Morton
Hitec/Multiplex USA
Technician/Service Rep.

--------------------------------------------------------------------------------
Posts: 373 | IP: Logged