[Grumbar]

Hi Everyone,

I am looking for Unionville beaver 40.size plans for the Horizontal stab and elevator, or if someone would be willing to build one and ship it, i am willing to pay for labor and materials. Let me know.

thanks,
Mike.

[Buzz]

I have the Unionville plans. I can see if I can get them scanned and send you the files.

[Buzz]

Ok....

Forget that, I just pulled out the plans, and for some reason, they dont show the horizontal stab. Must've been totally precut with no reason to show on plans.

Sorry.

[Max]

If it is a once piece stabilizer, then may I make a suggestion?
Get a scale drawing of the plane from a library book or search the internet.
ie:

Then measure the length of your fuselage from your plans and then measure the same on the scale drawing. Then divide one by the other. That would give you a "scale up" ratio. Then measure the length/width of the stab from the scale drawing and multiply by the ratio you calculated, and use that to come up with a correct scale drawing for your application. (you might want to add 10% to improve flight stability)


Alternatively, you can get the scale factor I mentioned above and once you know how wide the .40 size elevator should be, enlarge the tail section of the scale drawing you have (like the picture I attached) on a photocopier until it is the size you need. Then trace it onto a piece of balsa and cut it out.

[Grumbar]

Thanks Max,

Thats something i will diffently do right away, i will let you know how it goes.

Thanks again.

mike.

[Grumbar]

Hey Crash_23,

Thanks alot for the complete Tail feathers and Stabs, the beaver will fly again! He is a pic of the horizontal stab and tail elavators.

Mike.

[crash_23]

Hey Mike;
Made it back, pictures look good. Hopefully you get it back in the air soon. If you need anymore parts let me know. Nice meeting you.