Register Now

Wizard · 07-16-2007, 06:42 AM

i have an ofna 12 motor and it has excessive end play between the motor and flywheel..how can this be fixed??

Speed Metal · 07-16-2007, 08:16 AM

can you tell where the play is originating from? If I understand you correctly, you're saying that the collet doesn't butt right up against the front bearing, correct? If that's the case simply remove the flywheel and push the collet right up against the front bearing (or shim(s) ) and re-install the flywheel. Make sure the flywheel nut is good and tight and re-check it.

Pix would be helpful too.

regards

speed metal

matt2 · 07-16-2007, 09:48 AM

make sure you didnt run out off threads and the nut isnt bottomed out. Not allowing it to push the collet to the bearing.
Matt

c-low74 · 07-16-2007, 12:36 PM

Quote:

Originally Posted by matt

make sure you didnt run out off threads and the nut isnt bottomed out. Not allowing it to push the collet to the bearing.
Matt

+1

same thing i was thinking

07-16-2007, 06:42 AM	#1
Wizard RCC Pro Contributor Join Date: Mar 2005 Feedback: 0 / 0% Posts: 1,783 Total Props: 0	End Play??? Remove this ad - become a site supporter! i have an ofna 12 motor and it has excessive end play between the motor and flywheel..how can this be fixed?? __________________ 2-Brushless Kyosho Hang on Riders revo converstion MMM powered Brushless Gorillamaxx/Lipo powered Portable Nazcar Track(is here)+ 15 BRP cars Oshawazees.com WWW.BRPRACING.COM OZRACING D.R.C.R.C
	.

07-16-2007, 08:16 AM	#2
Speed Metal RCC Master Contributor I am: Bill N. Join Date: Apr 2006 Location: Purgatory (Ontario) Feedback: 0 / 0% Posts: 1,284 Total Props: 0	can you tell where the play is originating from? If I understand you correctly, you're saying that the collet doesn't butt right up against the front bearing, correct? If that's the case simply remove the flywheel and push the collet right up against the front bearing (or shim(s) ) and re-install the flywheel. Make sure the flywheel nut is good and tight and re-check it. Pix would be helpful too. regards speed metal __________________ Chequing Account Factory Team Driver. Proudly sponsored by debt and taxes.
	.

07-16-2007, 09:48 AM	#3
matt2 RCC Expert Contributor Join Date: Mar 2005 Feedback: 0 / 0% Posts: 803 Total Props: 0	make sure you didnt run out off threads and the nut isnt bottomed out. Not allowing it to push the collet to the bearing. Matt __________________ Niagara R/C Offroad Niagara R/C Indoor (carpet) Niagara R/C Indoor Offroad Niagara R/C Hobbies
	.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

vBulletin Message

Cancel Changes

Register Now

Log-in