|
|
|
| General RC Aircraft Discussion Discuss anything RC related |
 |
|
|
Thread Tools | Display Modes |
09-09-2013, 06:06 PM
|
#1 |
|
RCC Junior Contributor
I am: wilf h
Join Date: Dec 2012
Location: saskatoon saskatchewan
# of RCs: 1
Feedback: 4 / 100%
Posts: 212
Total Props: 1
|
what is it
Picked up his project today. Has webra 40 silver liner engine? Say's 6.5 on side of engine.
Not sure of make and manufacture of plane? Its a bit rough but will be fun rebuild. Wilf Need a muffler for this engine. |
|
 .
|
| Sponsored Links - Subscribe to remove this ad. |
|
|
|
09-09-2013, 07:10 PM
|
#2 |
|
RCC Apprentice
I am: Cameron T
Join Date: Apr 2009
Location: Orangeville
Radio of choice:
futaba 7c # of RCs: 10
Feedback: 0 / 0%
Posts: 92
Total Props: 1
|
Re: what is it
I'm gonna say its a Goldberg eagle 2. But theres something about the window in the back of the cabin that leaves me with some doubt. Might have been a little modification to make it more "scale' like
|
|
|
.
|
|
|
|
|
09-10-2013, 03:38 PM
|
#5 |
|
Administrator
★ Site Supporter ★★ Administrator ★
I am: Max P.
Join Date: Feb 2007
Location: Aurora, Ontario
Radio of choice:
JR and Spektrum Feedback: 77 / 100%
Posts: 19,799
Total Props: 232
|
Re: what is it
Ya. A skyward 40.
Make sure you check the control pushrods. The original design was kinda shaky. As far as ARF trainers go, it was one of the first when ARF's started arriving on the scene. It flew OK- sorta. But for a trainer, it wasn't a very good flier.
__________________
Transport Canada Advanced Flight Examiner; RC Test Pilot; FPV Instructor, Airplane Instructor; Helicopter Instructor My Aircraft Albums: https://www.rccanada.ca/rccforum/album.php?u=13173 |
|
|
.
|
|
09-10-2013, 09:35 PM
|
#6 |
|
RCC Senior Contributor
I am: Wade Z
Join Date: Dec 2002
Location: Scott's Point, NS
Feedback: 0 / 0%
Posts: 704
Total Props: 4
|
Re: what is it
I'd say Skyward 40 also. Have one, and it was a good flyer. Built my in 96, yes it came as a kit well before the BARF (built almost ready to fly)versions.
Most of the ones I've seen came with really crappy hinges, allowing for huge gaps between trailing edges and control surfaces.
__________________
Argus MAAC #57828 Living dangerously in the Low Fly Zone (seakings overhead !!!!) Aircraft Maintenence Engineer-Structures apprentice |
|
|
.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Linear Mode
Your Privacy Choices