Register Now

JVFan · 12-24-2003, 11:19 AM

Hello,

Somebody can tell me if I can find that paper in Quebec?

Thanks

Argus · 12-24-2003, 04:47 PM

Yves,
There is an inkjet decal thread on page 3(?) of this forum. Hope this will be of help.

Wade

yabut · 12-30-2003, 04:55 PM

I picked up some at the staples store they are avery # 08665 full sheet labels . I made a page in the printshop program with everything i needed on it printed it off and then cut out the decals. They need to be covered with a clear lacquer paint that wont be affected by the fuel . I think maybe 2 coats will be better than 1 I used armor coat clear finnish lacquer with 1 coat and it did soften a bit but did work try on scrap pieces first. The labels stick real good no second try and they will peal paint.
hope this helps

12-24-2003, 11:19 AM	#1
JVFan RCC Junior Contributor I am: Yves Sabourin Join Date: Sep 2003 Location: Laval, Qc, Canada Feedback: 1 / 100% Posts: 186 Total Props: 0	Where do I find the inkjet decal paper... Remove this ad - become a site supporter! Hello, Somebody can tell me if I can find that paper in Quebec? Thanks __________________ Yves "R-SABY 50" Laval, Quebec (Canada) MAAC 71660
	.

12-24-2003, 04:47 PM	#2
Argus RCC Senior Contributor I am: Wade Z Join Date: Dec 2002 Location: Scott's Point, NS Feedback: 0 / 0% Posts: 704 Total Props: 4	Inkjet Decals Yves, There is an inkjet decal thread on page 3(?) of this forum. Hope this will be of help. Wade __________________ Argus MAAC #57828 Living dangerously in the Low Fly Zone (seakings overhead !!!!) Aircraft Maintenence Engineer-Structures apprentice
	.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

12-30-2003, 04:55 PM	#3
yabut Guest Join Date: Jun 2003 Feedback: 0 / 0% Posts: 98 Total Props: 0	I picked up some at the staples store they are avery # 08665 full sheet labels . I made a page in the printshop program with everything i needed on it printed it off and then cut out the decals. They need to be covered with a clear lacquer paint that wont be affected by the fuel . I think maybe 2 coats will be better than 1 I used armor coat clear finnish lacquer with 1 coat and it did soften a bit but did work try on scrap pieces first. The labels stick real good no second try and they will peal paint. hope this helps
	.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

vBulletin Message

Cancel Changes

Register Now

Log-in