[dashpuppy]

Originally Posted by tporter416

Sure, the receiver has two levels of menus, the first is when the a light is flashing. The second is when the a light is solid.
The first point, you can adjust when a light is flashing, if it is drifting forward pull back the elevator a bit and this should adjust the level flight backwards. If this is not working then use the rudder in any direction in this menu to erase the setting.

For the second, the stick deadband, when the a led is flashing, press the button until you get to parameter e, the default is red flashing, change it to flashing blue and see if the problem goes away. Use the rudder I think to adjust. If the problem goes away you can go back to red solid and see if it is ok. Otherwise go back to red flashing.

For the third, is the setup menu, you need g solid, ensure your swash plate is level at 90 degree intervals all the way around on one blade. It may look ok in one direction or two but you need to check all four points at 90 degree intervals.

Thanks,

Tom

parameter Menu,

A)

do i do this while hovering ? or ?

[tporter416]

No, none of these are done during flying. They are ground adjustments, you might want to refer to the ar7200bx manual for more details on these.

Tom

[dashpuppy]

No luck today still tilt's forward TONS!

See video,
http://www.youtube.com/watch?v=sD7KA...ature=youtu.be

[tporter416]

I see the problem, it doesn't look like anything is hitting your beastx. The clearance looked ok, it also looks like you are using the same transmitter I am, a dx7s? Are your swash plate servo frequencies matched to the servos? Have you tried calling horizon hobbiesb1-800 number? Maybe it is a bad unit...

Thanks,

Tom

[dashpuppy]

Originally Posted by tporter416

I see the problem, it doesn't look like anything is hitting your beastx. The clearance looked ok, it also looks like you are using the same transmitter I am, a dx7s? Are your swash plate servo frequencies matched to the servos? Have you tried calling horizon hobbiesb1-800 number? Maybe it is a bad unit...

Thanks,

Tom

cyclic servos are at 200 Tail is at 333

Friend of mine just texted me said that the head speed sounds to low..

[tporter416]

There are a ton of goblins at my field, in stunt mode they tend to use 1950-2050rpm. My Titan x50 has a ar7200bx and it is fine at a head speed of 1550 before I change the flight mode to 1950 and it doesn't have the issue at any time. I heard a bit of a vibration on spool up but couldn't tell if that continued during flight...

Tom

[gothicbunny]

If it holds steady with back elevator, is there any chance you bumped a trim switch on your radio?

[dashpuppy]

Originally Posted by gothicbunny

If it holds steady with back elevator, is there any chance you bumped a trim switch on your radio?

No sub trim or any trims. it's a new model in radio new bind new setup still same issue every time..

[craneman32]

Are you sure CG is good. Holding heli by the grips and holding it in the air on its side? It stays horizontal?

[dashpuppy]

Originally Posted by craneman32

Are you sure CG is good. Holding heli by the grips and holding it in the air on its side? It stays horizontal?

did you watch the whole video ? ( sarcastically if you watched it ) you would see that i prove that