Register Now

Guest · 11-16-2004, 07:53 PM

I was looking for something to use as a Motor bench but wanted it to fold up. Tried several of the fold up benches all were to flimsy then at Home Depot a $39 folding quick jaw workbench that is very sturdy. And its mostly assembled took 15 min to put together.

Wolfcraft Quick Jaw Workbench model 6134.

All the tops seem to be particle board will be replacing it with hardwood soon but so far have run a Zenoah G62 on it and its solid but light so make sure you have it secured or weighted down or it might flip over. Also I used locktight on all nuts and bolts because of vibration.

Dennis Pratt

insomniac · 11-17-2004, 06:42 AM

Went to home depot looking for plastic tool box nothing excited me then i looked around and saw this Toolbag made by husky its got all kinds of compartments for tools glow drivers , also comes with a small plastic box to hold glowplugs screws nuts bolts , and a water bottle comes with it to, TOOLBAG is made of nylon covering but has rigid plastic inside, I built some stands out of copper and rivited two pipe hangers on each side to hold my aircraft , Works like a dream, COOL flightbox for $29.99 at home depot,

11-16-2004, 07:53 PM	#1
Guest Guest Join Date: Sep 2002 Feedback: 0 / 0% Posts: 0 Total Props: 57	Have You Come Across A Nifty Tool For the Shop Or Field Box? Remove this ad - become a site supporter! I was looking for something to use as a Motor bench but wanted it to fold up. Tried several of the fold up benches all were to flimsy then at Home Depot a $39 folding quick jaw workbench that is very sturdy. And its mostly assembled took 15 min to put together. Wolfcraft Quick Jaw Workbench model 6134. All the tops seem to be particle board will be replacing it with hardwood soon but so far have run a Zenoah G62 on it and its solid but light so make sure you have it secured or weighted down or it might flip over. Also I used locktight on all nuts and bolts because of vibration. Dennis Pratt
	.

11-17-2004, 06:42 AM	#2
insomniac RCC Senior Contributor I am: Eric Join Date: Oct 2004 Location: Mccullough lake ont Radio of choice: JR / Futaba # of RCs: 20 Feedback: 14 / 100% Posts: 595 Total Props: 0	TOOL BAG FOR FLIGHT BOX Went to home depot looking for plastic tool box nothing excited me then i looked around and saw this Toolbag made by husky its got all kinds of compartments for tools glow drivers , also comes with a small plastic box to hold glowplugs screws nuts bolts , and a water bottle comes with it to, TOOLBAG is made of nylon covering but has rigid plastic inside, I built some stands out of copper and rivited two pipe hangers on each side to hold my aircraft , Works like a dream, COOL flightbox for $29.99 at home depot, __________________ JR 9303, Futaba 9chp, spektrum dx3r pro Lanier Edge 540 with a zdz 80cc on a tuned pipe, Ohio Rc Extra 300 with a zdz 60cc rc4wd TF2, Scx10 Dingo, Gmade R1, Savage Flux HP, T-Maxx converted to brushless.
	.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)

vBulletin Message

Cancel Changes

Register Now

Log-in