|
|
11-14-2013, 09:18 PM | #1 |
RCC Noob
I am: Chris B
Join Date: Nov 2013
Location: Winnipeg, MB
Radio of choice:
Airtronics # of RCs: 6
Feedback: 0 / 0%
Posts: 11
Total Props: 0
|
Vaterra Twin Hammers RTR Receiver issue?
Hey guys, I ran my new RTR Twin Hammers today for the first time and I had an absolute gas. The problem was it began to develop moments where it didn't repond to the transmitter. When i went up and either lightly touched it with a finger or picked it up it then responded to the transmitter. The problem only occurred with the speed control and not the steering. Can someone tell me exactly what is happening here? I assume it is a receiver issue?
Thanks in advance |
. |
Sponsored Links - Subscribe to remove this ad. |
|
11-14-2013, 09:29 PM | #2 |
RCC Contributor
I am: Wes Quist
Join Date: Dec 2007
Location: Kelowna B.C
Radio of choice:
Spectrum DX7s # of RCs: 10
Feedback: 2 / 100%
Posts: 459
Total Props: 0
|
Re: Vaterra Twin Hammers RTR Receiver issue?
Try and re-bind as per the manual.
If that doesn't work call the Horizion Hobby Customer service, they are awesome! Chances are that they will send you a new RX or TX or both free of charge. There hasn't been to many problems with the Twin Hammers since they corrected the 2 speed tranny servo problem. Hope this helps.
__________________
Tech at ABC Hobby |
. |
11-14-2013, 09:34 PM | #3 | |
RCC Noob
I am: Chris B
Join Date: Nov 2013
Location: Winnipeg, MB
Radio of choice:
Airtronics # of RCs: 6
Feedback: 0 / 0%
Posts: 11
Total Props: 0
|
Re: Vaterra Twin Hammers RTR Receiver issue?
Quote:
I will give re-binding a go. I will definitely give them a buzz in the a.m. and see what they say. |
|
. |
|
|
11-15-2013, 05:23 PM | #4 |
RCC Noob
I am: Chris B
Join Date: Nov 2013
Location: Winnipeg, MB
Radio of choice:
Airtronics # of RCs: 6
Feedback: 0 / 0%
Posts: 11
Total Props: 0
|
Re: Vaterra Twin Hammers RTR Receiver issue?
Dug into the problem today. Once I managed to get the top off of the truck(12 screws later) the problem turned out to simply be a loose motor connection.
|
. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|