|
|
|
| Nostalgia - Old Timer Aircraft Everything about the good old days of RC! |
 |
|
|
Thread Tools | Display Modes |
09-04-2013, 10:19 PM
|
#1 |
|
RCC Apprentice
I am: Ken S
Join Date: Jan 2011
Location: Brantford Ontario
Radio of choice:
DX6i # of RCs: 14
Feedback: 0 / 0%
Posts: 63
Total Props: 2
|
Mills 1.3 and valve spout
Gooday all, I am hoping that somebody might be able to help me with a few questions.....??
I need a vintage plane from the 50's that would be a match for a Mills 1.3 diesel engine that I have, hopefully one that is not too difficult to build. Also, might anyone know where I might obtain a "valve spout" for fuelling. Can't seem to find one anywhere in North America. The Mills belonged to my father who was into free flight modeling in the early 50's. It would be nice to get it back into the air again....a good winter project!? Thanks. Later...Ken |
|
 .
|
| Sponsored Links - Subscribe to remove this ad. |
|
|
|
09-05-2013, 09:21 PM
|
#2 |
|
Administrator
★ Site Supporter ★
★ Site Supporter ★★ Administrator ★ 
I am: William A
Join Date: Mar 2006
Location: York, on
Radio of choice:
Futaba Feedback: 129 / 100%
Posts: 10,204
Total Props: 116
|
Re: Mills 1.3 and valve spout
Hey Ken, as for fuel filling an eye dropper or syringe will work fine.
As for models that fly on a Mills try these. You can also get short kit and plans for these models from Klarich Kits or just scratch one out from plans. Veron Deacon Veron Sky Scooter Madcap Heron Gas Buggy (my choice) Bill
__________________
''engine hoarder'' |
|
|
.
|
|
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
| Display Modes | |
|
Linear Mode
Your Privacy Choices