|04-02-2010, 06:27 PM||#1|
RCC Junior Contributor
I am: Jim D
Join Date: Jan 2003
Location: Orangeville, Ontario
Feedback: 0 / 0%
Total Props: 0
JR 9303 FM Failsafe programming
Remove this ad - become a site supporter!
I have a 9 channel receiver in my aircraft. Every channel is in use.
I just installed a opto gas engine kill switch and everything is functioning,however I wish it to kill the ignition in the event of signal loss or inadvertently turning off the radio.I have been told that in failsafe mode , if selected to hold ,it will continue at the last setting and therefore will continue to supply ignition.
Unfortunately the only receiver channel that I could put it into and have it operate off the desired switch, was position aux 4.
When bringing up the failsafe screen I can put all the other channels in " hold or failsafe", however aux 4 channel seems to be non selectable, displayed at lower right of the screen , and is in hold selection position
Can you change the aux 4 channel to failsafe or is it defaulted to hold.
If so , how do I go about it.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|