|04-13-2010, 07:08 PM||#1|
Join Date: Aug 2008
Feedback: 0 / 0%
Total Props: 0
Remove this ad - become a site supporter!
Hi all i just bought a hpi mt2 g3.0. Now i know from past rc cars screws tend to get loose . Now the owners manual says to check all screws and
such before running.
Ok that makes sense and i did go over the truck and tightened all the screws
but today i had only rear wheel drive got home and found out i lost a set screw on the front output shaft at the slipper clutch and the rear set screw
was about to leave town as well .
So i figure should you tear down a ready to run truck or car and rebuild with
treadlocker just to be safe Thanks for reading Larry
|04-14-2010, 09:34 AM||#2|
Level 3 Supporter
★ Site Supporter ★
I am: Gordon
Join Date: Jun 2007
Location: Toronto, Ontario
Radio of choice:
Spektrum DX9 BE, DX3R & DX3S
# of RCs: 30
Feedback: 17 / 100%
Total Props: 3
You will only need to use threadlock on metal screws to metal. Leave the plastic screws or metal screws to plastic.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|