|12-28-2010, 12:53 AM||#1|
I am: Stephane L
Join Date: Dec 2010
Location: Williams Lake, BC
# of RCs: 12
Feedback: 15 / 100%
Total Props: 11
Blade CP repair question
Remove this ad - become a site supporter!
I need to replace my main shaft and drive gear. It looks fairly straightforward but there is a cross pin near the top of the shaft by the rotor head. It looks like it is just held in by friction but would like confirmation from someone who knows before I pull it out and damage anything.
Anyone know for sure? - just pull it out and then push it back in when the new shaft is installed?
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Blade CP Battery Question||dash8||General RC Heli Discussion||2||09-27-2009 07:53 PM|
|wing repair question||Dzlstunter||Construction Ideas, Hints and Tips||2||06-11-2009 06:42 PM|
|Blade CP servo question||rmcdicken||General RC Heli Discussion||2||01-27-2008 01:27 PM|
|Blade question||Warbird_ace||General RC Heli Discussion||8||07-20-2006 07:28 PM|
|Tail blade question?||:L2K:CLUTCH||General RC Heli Discussion||6||03-05-2004 08:47 PM|