|04-08-2011, 01:35 PM||#1|
RCC Pro Contributor
I am: Eric K.
Join Date: Feb 2007
Location: Burlington ON
Feedback: 12 / 100%
Total Props: 10
Stamax 64mm A10 Twin rudder setup (mod)
Remove this ad - become a site supporter!
Before my plane gets picked up by the new owner, I just wanted to show the twin rudder modification. The pictures explain most of it...
The rudder linkages poke into holes under each rudder (acting as a pivot). The wire doesn't fall out as it runs full length between the two rudders with a Z bend through the servo arm (bent upwards slightly to create spring pressure into the holes).
Just make sure your rudder servo direction is compatible with the existing nose wheel steering (If not just reverse the servo by resoldering the motor and pot wires, or program as a spare channel tied to the rudder channel).
Zen thinking * It's rebuildable till it fits back in the box. **
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|A-10 STARMAX twin 64mm EDF $*** RTF (but no TX)||4stripes||FS - Airplanes||3||04-07-2011 05:44 PM|
|Starmax A-10 twin 64mm EDF||4stripes||Electric Jets||7||08-24-2010 08:55 AM|
|Zero binding twin rudder setup||hitechflyer||General RC Aircraft Discussion||10||12-20-2009 06:46 AM|
|Wanted: Gyro for rudder on Twin....||Concordefan||Wanted - Electronics||6||06-12-2006 09:26 AM|
|need some opinions -re rudder setup - new Extra 300L||AJCoholic||Giant Scale Aircraft||18||09-19-2004 08:41 PM|