|06-03-2011, 08:01 AM||#1|
RCC Supreme Contributor
I am: Cliff S
Join Date: Feb 2007
Location: Belleville Ont.
Radio of choice:
Hitec, Futaba - FM
# of RCs: 10
Feedback: 25 / 96%
Total Props: 13
Hitec Electron 5 and large servos
Remove this ad - become a site supporter!
I was wondering if those really large servos would put an excessive load on an Electron 5 receiver? Should I use some kind of an interface. It is for a simple project not one of those large flying money trees.
"If my being here has made your day a little more pleasant then I have done my job" Red Skelton 1913 - 1997 (famous Comedian)
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Hitec Electron 6 JR||floyd||FS - Electronics||7||05-16-2011 05:08 PM|
|Hitec Electron 6 RX||Struts1||FS - Electronics||1||03-14-2011 04:43 PM|
|New Hitec Electron 6 Receiver||stegl||FS - Electronics||2||02-13-2011 12:18 AM|
|New Hitec Electron 6 Receiver||stegl||FS - Electronics||0||02-07-2011 11:36 PM|
|Hitec Electron 6 Reciever- for Futaba or Hitec||astelz||FS - Electronics||2||12-04-2006 09:27 PM|