|05-03-2012, 04:58 PM||#1|
RCC Supreme Contributor
I am: StewartW
Join Date: Dec 2010
Location: Fort Sakatchewan, Alberta
Radio of choice:
# of RCs: 5
Feedback: 24 / 100%
Total Props: 12
MCPX - XTREME Aluminum Swash
Remove this ad - become a site supporter!
I bit the dirt with the MCPX today. Something I don't like about the Xtreme Productions swashplate upgrade. The pitch ball end is threaded into the swash. Very tiny and weak! I never noticed but Im sure they were loose or bent before today. I can't find replacements ball ends is the problem. You have to buy the whole swash.
Permanent Locktite works wonders! I still want to let it sit over night before I test it out. You can see where the red Loctite was applied.
PS camera is working fine now.
Trex 700E V2 DFC upgrade w/Demon 3sx
Trex 600E Pro w/Ar7200bx and KDE 530kv on 12s
Trex 450 Sport V2 w/2010kv Scorpion 6s, Dx7s
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|NIP logo 500/600 aluminum swash||rcmarty||FS - Helicopters & MultiRotors||7||06-17-2014 12:46 AM|
|Wanted: MCPX Salvage / MCPX Parts(even damaged ones)||Edwii||Wanted - Helicopters + Heli Gear||1||05-11-2012 04:52 PM|
|WTB MCPX V1 3in1 board or MCPX V1 BNF||Dragan||Wanted - Electronics||1||03-30-2012 03:06 PM|
|Swash Mix||craneman32||General RC Heli Discussion||2||04-26-2011 08:21 AM|
|DX6i and JR tx Aluminum roller and Aluminum trim tabs||Naterpin||FS - Other RC||24||02-27-2010 10:12 PM|