|05-31-2012, 05:25 PM||#1|
RCC Expert Contributor
I am: Bill M
Join Date: Nov 2003
Location: Kitchener ON.
Feedback: 2 / 100%
Total Props: 0
Interestng Carb problem.....
Remove this ad - become a site supporter!
So, i need some input. I have an old Brison 4.2 side carb engine, i just rebuilt the carb and it is running flawless, without the cowl.... if i put the cowl on it runs perfectly unless inverted, or if i pull up at low throttle to enter a hover it quits, it quits if i roll knife edge. it will pull vertical and be fine as long as it has power on. if i remove the cowl it runs just fine. i am thinking it is a pressure issue but i thought that it caused the engine to richen, but its acting lean. we even had 3 guys hold it vertical on theground like we were checkin a little nitro burner(looked pretty funny) and adjustig needles didnt fix anything.Any ideas guys?
There is no such thing as too low
|05-31-2012, 06:04 PM||#2|
RCC Senior Contributor
I am: Phil Schulte
Join Date: Apr 2009
Location: Prince George B. C.
Radio of choice:
# of RCs: 40+
Feedback: 3 / 100%
Total Props: 3
Re: Interestng Carb problem.....
I put the diaphram that is on the side that has the hole to sense outside air pressure backwards. The engine would run but was very sensitive to air pressure. would run on the ground but terrible once in the air. Just a thought maybe check the diaphram. I found it backwards after I got mad and replaced engine after three deadstics in a row.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Problem with fuel inlet on walbro carb||Trumpetman||Large Engines||4||06-21-2011 08:50 PM|
|Carb problem||sylo26||Engines||10||09-05-2008 02:45 PM|
|Carb adapter for Perry carb to Fox .78 engine||ModelBuilder||Wanted - Engines||2||06-19-2006 04:35 PM|
|Is my Triton charger having a problem??? (PROBLEM FIXED!!!)||Heli-Flyer||Electronics||5||06-07-2004 10:38 AM|
|Wild Hare Edge Aileron Problem! NEW: Problem addressed!!!!||Brian Facey||Scale Aerobatics||7||04-18-2004 09:10 AM|