|08-20-2012, 07:31 AM||#1|
Level 3 Supporter
★ Site Supporter ★
I am: David C
Join Date: Jul 2010
Location: Morewood, ON
Radio of choice:
MC-20 MX-20 X9D+ X12S
# of RCs: 25
Feedback: 72 / 100%
Total Props: 44
Remove this ad - become a site supporter!
If you need to inject some Gorilla glue into a small gap or crack you gotta get some of these. Screw them on to a syringe, pull out the stopper, squirt some G-Glue into the syringe, then hold it with the tip up and push the stopper up into it until all the air is pushed out. (just like the doctors do in cheesy drama shows)
You need to put quite a bit of pressure on the syringe with the smaller tips to push the fairly thick G-Glue.
Also try some of these for harder to reach areas.
When you are done and the syringe is empty, pull it apart and wipe out the glue. Also squirt air through the tip to remove as much glue as you can. Disassemble everything and wipe the glue out. Then when it is sets, it pops right out so you can use them again if you need to conserve. The G-Glue doesn't stick the syringe or tip.
MC-20 MX-20 Taranis X9DPlus HORUS
Friends don't let friends fly Spektrum!
Electric flying is pretty much seeing how close to a dead short you can run without setting it on fire.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|The last glue......||cadcamguy||General RC Aircraft Discussion||14||03-17-2011 10:48 PM|
|What glue||IAR 80||Construction Ideas, Hints and Tips||8||11-06-2009 07:01 AM|
|How much glue?||Newbie flyer||Construction Ideas, Hints and Tips||16||04-23-2005 09:13 PM|
|what glue to use||dream starter||Construction Ideas, Hints and Tips||8||12-11-2004 02:43 AM|
|Glue??||Norm||General RC Aircraft Discussion||3||01-12-2004 11:23 PM|