|09-13-2012, 08:57 PM||#1|
I am: Dan D
Join Date: Mar 2005
Feedback: 1 / 100%
Total Props: 0
8fg to 10cg trainer problems
Remove this ad - become a site supporter!
I am using the proper 12fg cable which is hooked up the right way, trainer functions in 8fg are on "func", 10c is not turned on other than through the cable on a blank model, head speed in norm is around 1800 and when not hooked to the 10c, the 8fg works perfect. The 10c works perfect when checking as slave before starting the 600n. However, as the 10c gets control when 8fg trainer switch is pulled after engine is started, alls well until the heli just starts to get light on the skids and then throttle just starts to increase to full bore without changing the collective. I tried it with a 7cg and it does the exact same thing. I'm stumped. Any ideas?
Never lie, and never minimize or gloss. Tell it like it is and let the pieces fall where they may. The truth always wins.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Futaba 8FG||rollin_3z||FS - Electronics||0||01-26-2012 02:03 AM|
|8FG problem||Kevin Rochon||General RC Aircraft Discussion||10||11-08-2011 09:45 PM|
|Futaba 8FG!||Leepord geko||FS - Electronics||6||10-04-2011 11:17 AM|
|Futaba 10CG 10C 2.4ghz Fasst RC Heli Radio $350||jsflysrc||FS - Electronics||0||09-29-2011 08:58 PM|
|Like New Futaba 8FG For sale!||OICU812||FS - Electric Gear||11||09-12-2011 10:03 AM|