|11-01-2006, 12:10 PM||#1|
RCC Junior Contributor
FS: Fully Modded Tamiya TG10 Mk.2 Pro!
Remove this ad - become a site supporter!
I dont want to sell it, but I may have to...
This car is fully done from a-z. I went through countless hours of internet searching and shopping to get this car the way it is now.
Some of the mods I can remember are:
Square Ti Screw Set
Square output shafts
Square Universal Prop shafts
Tamiya Ti Turn Buckles
Racy Ti (teflon coated) pivot balls
Racy One piece carbon upper deck
Racy front and rear shock toweres
Custom carbon transponer holder
Racy high performance cross drilled brake disk
Modified Gas tank area to fit ofna cd-3 tank (for longer run times )
Modified bottm chassis (cut sections to reduce weight and help weight transfer ect..)
Tamiya TRF One Piece Engine Mount
Ceramic bearing for the entire Drivetrain
And many more options. Believe it or not this car is as light as a RRR and has no problems competing with any of the cars out there today. It's VERY fast and corners like a train when you get setup right. This car has made some of the people at my local tracks re-think thier opinion on shaft cars.
I have some good electronics on the car as well:
Futaba S9451 Digital Servo (front)
HiTec HS-5645MG Digital Ultra torque Servo (throttle)
AMB Personal Transponder
Also, I have an OS TZ 3 Port Dark Force Engine that has been hand modified by Van Zeppin from Zeppin racing. This motor is so sick fast that I was amazed. I ran the engine for ONE race and thats it.
Light weight low center gravity hump pack.
I'm sure i've missed out on a few things, but can assure you that im no scammer and that this car has LOTS of money put into it....more than meets the eye.
I havnt thought of how much I want to sell everything for and would prefer to sell the car as a whole with everything on it.
Car comes with spare parts and 3 bodies included. One body is a Tamiya Ferrari 360 body, the other is a Parma Type M and a Mazda 3.
Offers are welcome. Looking to get $750 for everything listed.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|