|01-06-2008, 03:36 PM||#1|
Team Orion WASP .26
Remove this ad - become a site supporter!
Selling one of my motors... I dont need 10 motors......
The motor is in great condtion.. The bearings are very tight. I just pull the back plate off to inspect the rod and bearing..
Here is some INFO on the motor..
$110... Thats cheap power 2.7 HP....
Team Orion WASP 26 Pull Start 2.7HP Nitro Engine 86400
The POWERFUL 2.7HP TEAM ORION WASP 26 is an incredible .26 BIG BLOCK nitro engine! The Team Orion Wasp 26 is made by Picco and is based on the Picco P3 engine design.
NOTE: A customer recently told us that the machining on the Wasp cooling head has changed a little. Minor cosmetic change... still silver, just a slightly different shape than what is shown in the picture above. Apparently, Team Orion did not want their Picco (Wasp) 26 version looking too much like the Ofna version.
This high quality Picco engine offers the best of both worlds... with its BIG .26 cu. in. (4.3 cc) displacement that helps generate BIG POWER and TORQUE at lower-midrange engine RPMs while the Picco design also gives extremely powerful HP levels at higher RPMs.
This amazing .26 engine is made by Picco - a very well known, high quality, high powered engine manufacturer in Italy. The Wasp 26 is based on the Picco P3 engine design and is rated at 2.7HP.
This engine has a composite carburetor body to reduce heat transfer to the carb and help increase power output. The composite carb design should also help enable solid tuning of the air/fuel mixture. The Wasp 26 also has a 14mm crankshaft, hard chromed cylinder sleeve (ABC construction), double bushing connecting rod, and a convenient pull start mechanism. The Team Orion Wasp 26 nitro engine comes with a high flowing 5 port + 2 by-pass port design.
|Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)|